3016 Workstation Communications WSCOMM: Recorder is flushing, can't accept new commands All The workstation has sent a command while the recorder is flushing. This may indicate that the two are no longer synchronized, i.e. the workstation was rebooted or the recorder has been operated from the diagnostic monitor. This error will also be reported if the recorder and workstation become unsynchronized through other sequences of events. It is best to re-boot the workstation and recorder if possible. If this error is reported after the workstation was re-booted and the recorder wasn't, or if the recorder has been operated through the diagnostic monitor, then no further action other than re-booting is necessary. Otherwise, the debug log containing the events leading up to the error should be saved and forwarded to the responsible firmware programmer. Re-boot the workstation and recorder. If this error occurs more than once, report the details to Creo service. Workstation rebooted while images are active Recorder operated independantly from workstation through the diagnostic monitor Possible firmware bug ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:32:19 2008 PST